Universal piston ring measuring 44mm x 1.5mm with a GI enclosure. Used on many many kits. Check yours to see if ya need this one. Used on lots of 44mm airsal kits and alu kits for puch, tomos and derbi.
Tomos a35 44mm Airsal kit with everything you'll need.
Tomos a55 44mm Airsal kit - massive fins for super cooling abilities.
Tomos a35 and a55 unstuffed race crank from DMP. Awesome upgrade from your stock crank. This crank uses a 12 x 15 x 15 small end needle bearing but does not come with it so grab it if you need it.
Clear light up spark plug cap for checking your spark and having an awesome glow down by your engine.
Replacement 70cc 44mm airsal piston for the tomos 44mm airsal kits just in case you blew yours up. Or you can get just the 44mm piston ring for this.
NGK spark plugs. BHS series. Best in the world!
Super awesome 5mm Tygon fuel line for all your fuel flowing needs.
Folding Pegs for you and a buddy. These mount over the rear shock bolt.
NGK spark plug boot LB05EP. This is the resistor type that uses the little cap on the tip of the plug. 90 degree bend for those hard to reach places!
Red light up spark plug cap for checking your spark and having an awesome glow down by your engine.
Used internal driving gear for Tomos a35 and a55 engines.
Awesome upgrade Dellorto SHA carb for most bikes.
Spring loaded EBR front forks for Tomos and Puch Maxi - disc brake only!
Replacement black handlebar clamp for maxi and magnum EBR forks.
Black hydraulic Grimeca style brake caliper for front disc brake set-ups. This bolts directly onto non-hydraulic EBR forks. Grab a front hydraulic brake line, some brake fluid and a master cylinder too, if you need em.
Super nice quality master cylinder and front brake lever for any custom hydraulic brake set up. Works well on dirt bike conversion setups. Ben ran this master cylinder on his race bike.
Super nice quality adjustable 280mm rear shocks. 10mm eyelets.
Super nice quality superman shape tail light for letting the folks behind ya know you're there.
Super nice quality supermanish shape tail light for letting the folks behind ya know you're there.
Trail Tech A/C Voltage Regulator. Stop blowing out those lights on kitted bikes! -Improved A/C Regulator with Adjustable Output.
+25lbs of resistance from the stock spring for 1st and 2nd puch za50 and tomos clutches, saxonette clutches and m101 rear variators.
+30lbs of resistance from the stock spring for 1st and 2nd puch za50 and tomos clutches, saxonette clutches and m101 rear variators.
OEM Tomos 12mm sealed rear axle.
Small fuel filter for all mopeds. Perfect for tight spaces like moby or maxi!
TOP performance race crankshaft for Tomos a35 and a55 engines.
Beautifully designed and expertly welded high quality clutch made by our friends at Dream Team Tuning for Tomos A35 and A55. Included is a modified balanced Tomos clutch bell and a handmade 1st gear clutch.
Specially designed tool for holding the Dream Team Tomos clutch so you can tighten or loosen the crankshaft nut. This will make changing out the washers to tune your clutch way easier.
Change your plug on the go with this 3/16" spark plug tool.
Single filament BAY15D bayonet base bulb for moped tail lights. 12v/8w.
Dual filament double contact BAY15D bayonet base bulb for moped tail lights. 6.5 Volt 1.02 Amp 6.63 Watt.
Dual filament double contact BAY15D bayonet base bulb for moped tail lights. 13.5 Volt .69 Amp 9.32 Watt.
HPI CDI mini rotor ignition for all puch engines, e-50, za50, also tomos A35, tomos A55, derbi, sachs. Super curve with awesome 60w lights.
Crankshaft seal for Puch ZA50, Tomos A3, A35, A55, Minarelli v1, Morini M1 and M01.
Yuasa YTX4L-BS replacement 12v battery for Tomos Streetmate. This comes with a separate acid pack and the little terminal screws.
Performance replacement for any crankshaft needing a 12 x 15 x 15 needle bearing - Puch, Tomos, Minarelli, Morini, Derbi, Peugeot.
Used 16 inch front mag wheel for Tomos. This has a brand new 16" x 2.5" Sava B8 tire mounted to it. The bearings spin great, so just pop in your axle and brake plate and you're ready to roll.
Nice chrome gas cap for any tank using 30mm caps.
Super heavy duty universal ignition condenser for wiring externally. Get some new connectors if you need them.
Replacement BA20D bulb for Tomos mopeds and many scooters. 12v 45/40w.
Used 16 inch rear mag wheel for Tomos. The bearings spin great, so just pop in your axle and brake plate and you're ready to roll.
This is all the replacement hardware needed for Tomos a35 or a55 engine case, clutch cover AND flywheel cover. Super fresh.
Malossi carbon fiber reed block for puch polini cylinders, tomos a35 and peugeot 103.
You need this insert for superman tail light assemblies. This is the two bulb style, one for a 5w bulb and one for a 10w bulb.
Square black head light. Just like the ones that came on Tomos bikes. Uses a BA20D bulb.
Rear sprocket for Tomos a35 and a55 with 22 teeth. The ID on this is 42.5mm.
BiTurbo power for your a55.
Great performance upgrade pipe for Tomos a3 and a35 engines. Snatch up all the low end you can with this one!