Puch 19mm PISTON PORT intake for PHBG carbs. This has a square port on the bottom.
Replacement intake for Malossi 4 petal reed blocks. This is for PHBG clamp style carbs. 20mm ID
Stock reed block that comes with the Puch Polini 43.5mm 65cc cylinder kit. These will also fit stock Peugeot engines, and stock Tomos a35 engines.-Comes with two gaskets-Reed paper is 0.3mm thick.
15mm intake for puch polini reed valve kits.
20mm square port intake for Dellorto PHBG clamp or spigot carbs.
0.4mm Boyesen carbon tech single stage reeds for Honda Hobbit and PA50, NU50, NC50, and NA50. Boyesen markets these as "the best power increase for your money". These will dramatically increase the amount of torque and overall power for your engine.
15mm intake for use with dellorto SHA carburetors. Use this with your av7 or av88 engines.
Stock original reed block that comes with the Puch Gila 74cc cylinder kit. This will also fit Derbi flatreed 4 petal reed blocks, Aprilia rs50, Derbi GPR, Senda, and any Minarelli AM6 engine.
Budget version replacement reed block with metal reeds for lots of bikes. Details within...
15mm bing intake with big ole square port. Match this up with a brand new 15 bing carb and get rippin!
Stock like 15mm intake for Tomos A35. The biggest advantage of this intake is to get easy access to the carb - no more dropping the motor down just to change a jet! This is the oil injected version so be sure to plug that up with an m6 bolt and o-ring on the bolt if you're not using the injection. ID - 15mmOD - 18mm
Used Garelli 12.5mm intake.