Used dashboard with speedometer and a whole mess of wires and switches originally for Puch Magnum, but you can use this on any Puch.
Used dashboard cover originally for Puch Magnum, but you can use this on any Puch.
Used seat cowl off of a Sachs G3, though you can probably toss this on any custom project.
Universal red grill for all 4.5" or 5" moped head lights. Get to grillin and don't forget the A-1 sauce.
Oldschool license plate for most pre-70's motobecane's. This is used and rusty, but should clean up nice for anyone doing a restoration.
Oldschool tail light for most pre-70's motobecane's. This is a used part, the plastic is old, so be gentle with it.
Used plastic tank cover for a Tomos tx50 mini dirtbike.
Used plastic right side panel for a Tomos tx50 mini dirtbike.
Used plastic left side panel for a Tomos tx50 mini dirtbike.
New old stock number plate for motobecane VLX.
Used engine cowl in green for tomos a35 mopeds.
Used tomos a35 rear fender in green. Its ugly and dinged in some spots. But it's cheap and if here if you neeeeed it.
New old stock kinetic magnum frame with wire harness. Super cool start to a custom vespa build!
New old stock leg shields for motobecane. I've always wanted a set of these but the boss says i can't keep em so here they are. Be sure to get the hardware mounting kit for these before they're all gone...These are nos but have some shelf wear so no complaints! I sure wish i could keep em....
Universal number plate for racers, dirt pedders and bad asses alike. Drill your own mounting holes. Roughly 9" x 11"
used, scratched, dinged, stained, dropped, loved, hated, faded, desecrated, inebriated puch windshield.
New old stock fiberglass skid plate for "P" series engines. This probably came on lots of bikes - indian, aermacchi, early harleys, etc. Check the bolt pattern on this before you buy it to make sure it'll fit. If they don't match up, I bet you could drill your own holes to mount it to pretty much anything!You can refer to this minarelli p4 shop manual for oem part numbers and diagrams.
New old stock CEV speedometer cover shroud holder cover thing. Yeah. Looks like theres some extra space to drill holes and mount some custom switches.
Original trunk nut for motomarina sebring mopeds.**UPDATE** the ones we have left have rusty threads but we tested them all and they thread onto anything m6 x 1mm.
Head light visor for specific Avanti fairings. Check out the images to see what this normally mounts to.
Original Motobecane leg shield mounting hardware kit. Get the leg shields too before they're gone....
Finally a dashboard solution for almost any moped!
Used Derbi white headlight fairing. Has a small crack in the upper part. Should be fine as long as you're gennnntle with it.
These have small cracks but are still fully functional as long as you're gentle with them.
Finally time to throw that scoop on your derbi like you've always wanted to. Air cooled for the winnnn.
Used Derbi DS50 dashboard with speedo, gas gauge, turn signal and light indicators.