Clutch drum puller for all Motobecane mopeds - av7, av88 and av10. Also the correct puller for honda hobbit rear variator.
Extra long variator and flywheel nut for Motobecane mopeds. Use this for stock variators, doppler ER2/ER3 variators and flywheel nut for MBK CDI. This is a clockwise/regular thread for aftermarket MBK crankshafts.
Plastic Motobecane 3 ball variator roller ball guide.
Set of three 10 gram steel roller ball variator weights for stock Motobecane av7 and av10 variators. Grab the roller guide too, if you need it.
Replacement ramp plate for stock Motobecane av7 and av10 variators.
24mm reverse thread nut for stock av7 and av10 motobecane variators. This is the left hand nut that goes on the bottom/back side of stock MBK variator assemblies.
OEM variator nut for Motobecane mopeds.
New replacement complete variator unit for motobecane av7 or av10.
Replacement clutch drum for stock av7 and av10 variators. Not for the non-variated clutches.
Caged needle bearing for stock Motobecane variators.
This is a re-manufactured four ball roller weight guide for stock motobecane av7 and av10 variators. Run this with only two of the roller weights for better performance!
OEM and NOS motobecane variator shaft for av7, av10, 50v, 51v variators. These are a little rusty from sitting for years and years but they should clean up well with some steel wool. Here's some more moby variator parts.
OEM and NOS clutch bell for Motobecane av7 and av10 stock variators. Here's some more moby variator parts.
NOS Motobecane variator guard. This style came on non-variated dimobys. You need this if you want to ride your moby in the rain.
stock starter clutch shoes for stock motobecane variators.